Three, in the installation of the 1 links, elbow, valve need to be in the same uniform design thickness, the gap in the joints need to use professional glue to seal it.
2, in the installation must pay attention to the installation order, tubular pipe, if it is with the elbows, it is necessary to pay attention to the first elbow and straight, and finally the valve. The order is to reduce unnecessary trouble when you are installing.
3, glue bonding time to pay attention to don't too hard, in the interface of the material is in a slight squeeze under the stick and, so that may look very detail, but the problem, but this note can give back to reduce trouble.
4, pay attention to the gap between at both ends and the pipes in the cooling water and refrigeration equipment installation, Armaflex insulation materials like rubber tubes are required to apply the glue bonding, bonding width should to be thinner than the thickness of the rubber materials. Only in this way easier to pipe is connected.
5, in large-diameter plastic pipe because of the packaging has become oval, this time the Armaflex insulation materials can also be used, we want to save materials, so you can rip up please cesarean section compared with the flat side, use the other half to use as a material.